Vollrath Mix60-Water Cooled - Manual (Page 11)

English
Operating instructions
11
Note: The water expelled from the condenser, though being hot and not safe for consumption, is not polluted and can
be reutilised.
Before storing the device in rooms with a temperature lower to 0°C (32°F) it is IMPORTANT to get rid of
the water in the condenser (with WATER condensation) and in the inlet, outlet and washing pipes. Call
your Service technician.
5.6 Initial functioning check
At the end of the installation, and before using the device, it is important to let a qualified technician
check for correct connection, by performing the following procedure.
- Before proceeding, check that the circuit breaker is in the off ("0") position;
- insert the plug and turn on ("1") the circuit breaker, only the green light of the START button [Z1] should light up on the
control panel;
- close the lid and press the START button [K1]. The machine prepares to operate and tank temperature appears on
the display;
Note: if “ ooo” (three small squares) appears on the display, the impeller cover with it's polarized magnet is not
correctly placed. The machine will not work in these conditions.
- press the SLOW BEATING ACTION button [K4] and observe BEATER rotation. If it is COUNTERCLOCKWISE (as
shown in the drawing) the machine is connected correctly and is ready for use;
Note: do not unnecessarily start heating cycle or refrigerator.
- if rotation is in a CLOCKWISE direction, three-phase connection voltage is wrong and must be modified as
follows:
- Turn off the device by pressing ON/OFF [K1];
TURN THE MAIN CIRCUIT BREAKER OFF ("0") AND PULL THE PLUG
OUT OF THE RECEPTICLE;
- Open the plug’s shell and invert TWO of the THREE conductors connected at the
phases (R- S, R- T or S- T);
- Close the plug’s shell, plug in the device and repeat the check.