Vollrath Mix60-Water Cooled - Manual (Page 7)

English
Operating instructions
7
- Remove both the side panels unscrewing the relevant fixing screws [21];
- remove shipping bolts at bottom of frame [22];
The power cable is located at the bottom of the machine. Make sure not to damage the cable during the
lifting process.
- Lift the device from the pallet working from the lower side of the frame near the wheels. Remove the pallet and place
the device on the floor, and lean the device slowly on the floor avoiding bumps;
DO NOT insert objects, ropes or brackets for lifting THROUGH the device, since these could damage the
internal parts.
- Replace side panels;
- Packing material, which is produced with entirely recyclable materials ( ).
- Dispose of packing material properly
5 I
NSTALLATION
THE INSTALLATION MUST BE CARRIED OUT ONLY BY A QUALIFIED SERVICE TECHNICIAN AND IN
COMPLIANCE WITH STATE AND LOCAL CODES. ALWAYS FOLLOW MANUFACTURER'S INSTRUCTIONS.
5.1 Equipment location and parts verification
Place the device on the floor, on a flat and level surface capable of supporting the
equipment's specified weight.
Install the device away from any source of heat, avoiding direct exposure to the sun.
Make sure that air can freely circulate around each side of the device.
Check that all of the listed components are present:
- lid [5] attached to the machine;
- Drip tray [26] with bracket [27];
- Tap [11] including: inner body [12]; piston [13]; cover [14], lever [15]; fastening knob [16];
- all the technical documentation (in addition to this handbook): the Technical Handbook, the EC’s Conformity Certi-
fication and Electrical Test’s Schedule.