Vollrath Mix60-Water Cooled User Manual
Page 6
English
Mixer
6
4
T
RASPORTING
,
LIFTING AND UNPACKING
Note:
Should only be carried out by a qualified service technician. Transportation, unpacking and installation.
TO LIFT THE DEVICE ALWAYS USE AN ADEQUATE LIFTING DEVICE.
ATTEMPTING TO LIFT IT MANUALLY IS DANGEROUS AND CAN RE-
SULT IN SERIOUS INJURY.
The device’s weight specifications, both inclusive of packaging and net, can be found
in both the supplied documents and on the packaging itself.
To prevent the oil contained in the compressor from flowing into the refrigeration circuit, the machine
must be kept in an upright position, during carrying and during the installation and operation. Always
follow the instructions on the packaging.
4.1
Transportation of the crated equipment
The packaging has been designed to assure the equipments protection.
It is therefore suggested to transport the device while it is packed as near as possible
to the place where it will be installed.
To carry the packed device, use fork lift, or similar device, inserting its forks into the
holes of the skid.
4.2
Unpacking
-
WOOD PACKING: pry nails from the top panel, then separate the side panels.
-
CARDBOARD PACKING; cut the bands and pull the cardboard up from the top;
After having opened the packing, make sure the device isn’t damaged. In case of doubt, do not use it. Contact the seller
immediately.
REMOVAL OF SIDE PANELS MUST BE PREFORMED BY A QUALIFIED SERVICE TECHNICIAN ONLY.
EQUIPMENT MUST BE REMOVED FROM CRATING SKID PRIOR TO INSTALLATION AND OPERATION.
MAKE SURE NOT TO DAMAGE THE INTERNAL PARTS OF THE DEVICE.