Vollrath Mix60-Water Cooled - Manual (Page 16)

English
Mixer
16
BURN HAZARD: DURING THE HEATING CYCLE, THE PRODUCT BE-
COMES VERY HOT (+65/149°F...+90°C/194°F). SERIOUS INSURY CAN
BE CAUSED BY CONTACT WITH THE LID [5], THE TAP [11] AND THE
DEVICE'S SURFACE [35]. WHEN LID IS OPENED THE MACHINE DO
NOT STOP AND THE MIXTURE REMAINS VERY HOT.
ALWAYS VERIFY THAT HEATING/COOLING CYCLE IS COMPLETED OR,
THAT DISPLAY SHOWS A SUFFICIENTLY LOW TEMPERATURE
BEFORE OPENING LID OR TAP.
Note: the total cycle lasts approximately 90…120 minutes and varies according to the mixture quantity, type and
viscosity.
- wait until the process is finished. This is signalled on the display by the low conservation temperature [Tcp].
Note: once the lid is properly closed and the light [Z5] of the [K5] HEATING/COOLING button is on, the machine
monitors and maintains the conservation of the mix at the pre-set temperature [Tcp].
In case ingredients need to be added to the mixture:
- open the lid;
- add the ingredients and close the lid;
The mix is extracted as follows:
: - turn drip tray [26] sideways and place suitable container beneath
the tap;
- - extract the required quantity of mix by turning the extraction
tap counter clockwise. Quantities can be measured using the
gauge supplied [40]. Turn off the tap and place the drip tray
under it;
When all of the mixture is completely extracted, turn machine off.
6.5 Partial tap washing
Immediately following an extraction of mix (however small), all traces
of the mix must be removed from the inside of the tap. This is to keep
the tap clear for a later extraction.
Note: partial washing is carried out with the tap turned off.
Place a container under the extraction tap and press the WASH button [K9]. Allow the water to run until it is clear. Then stop
the process by pressing the WASH button [K9] again.
7 W
ASHING
THE FATS CONTAINED IN THE ICE CREAM MIXTURES PROMOTE FOR THE GROWTH OF BACTERIA,
CAREFULLY CLEAN AND SANITIZE ALL SURFACES IN CONTACT WITH PRODUCT.
In accordance with current health regulations, complete washing of all parts coming into contact with the product must be
carried out. During such operation, all removable parts must be detached from the machine and washed separately.
Note: additionally to the operations mentioned in this Chapter, it is recommended to clean machine’s outer panels and
all outside parts, taking particular care to clean drip tray [26] and its bracket [27], after removing them from the
front panel.
To avoid damage to the equipment do not use water in excess of 100°F, solvents, abrasive detergents, or
abrasive cleaning pads, especially on the plastic parts.