Vollrath Mix60-Water Cooled - Manual (Page 15)

English
Operating instructions
15
6.4 Production
Check that the condenser's water supply faucet is open;
- Before beginning the production, wash, rinse and sanitize (see section 7 - WASHING).
Note: If you plan to have more than one consecutive production cycle, you can avoid washing between cycles, mak-
ing sure you begin with the more neutral flavored mixtures.
- check that the START light [Z1] is on. If it is not, check that the plug has been inserted properly and that the circuit
breaker is on ("1");
- check that the lid is closed and the impeller cover in place;
- press ON/OFF [K1].
- check that the mix extraction tap is completely turned off (turned completely towards the right) and transfer the mix to
be heated into the tank. MAXIMUM tank capacity is 60 litres, recommended MINIMUM quantities are generally:
- 1/2 of maximum capacity during heating/cooling;
- 1/3 of maximum capacity during preservation.
Too little mixture can cause excessive overheating or the development of ice causing damage or irregu-
lar flow and foam during production; too much mixture can slow down or not complete the process of
heating/cooling and cause overspills.
- add ingredients to heated/cooling;
- close lid; if you require to pre- blend the ingredients, operate whipper by pressing FAST BEATING[K4], when ready,
press it again, to stop whipper;
- having programmed (see par 6. 3. PROGRAMMING THE HEATING AND COOLING CYCLE), press the HEATING/
COOLING button [K5];