Kodak 4600 - Manual (Page 26)

SERVICE MANUAL
26 18NOV97 – SM5440-1
Adjustment Specification
This adjustment adjusts the strobe and timing of the INDEXER LEVER. The gate edge of the black plastic of the
INDEXER LEVER should be between the 2 holes at position 2.
Adjusting the INDEXER LEVER ASSEMBLY
Warning
Dangerous Voltage
[1] Disconnect the main power.
[2] Do the removal for the MECHANISM ASSEMBLY.
[3] Place the MECHANISM ASSEMBLY on the MECHANISM RUNNING FIXTURE.
[4] Check the alignment of the INDEXER LEVER with the hole in the TOP PLATE ASSEMBLY at Position 1.
[5] Bend the INDEXER LEVER to the correct position.
[6] Check the travel of the INDEXER LEVER in the FORWARD position. When the INDEXER LEVER moves in
the FORWARD position, the gate edge of the black plastic should be between the 2 holes at Position 2.
[7] Bend the INDEXER LEVER until you reach the correct position.
Adjustment Specification
Use a MECHANISM RUNNING FIXTURE. Use TL-3001 to measure the height of the SLIDE LIFT LEVER. The
LEVER should make contact with the low surface of TL-3001. The LEVER should not make contact with the high
surface of TL-3001.
position 1 position 2
A091_0008HA
MECHANISM
RUNNING FIXTURE
MECHANISM
ASSEMBLY TOP PLATE
Bend
here.
A091_0008HCA