Kodak 500 - Manual (Page 53)

Troubleshooting
www.kodak.com/go/support 47
Light blinks green Pictures are being transferred
to the computer. None required.
After transferring pictures, the Transfer
light continues to blink green until
either the Transfer button is pressed
again or the connection is no longer
available.
Light is off There are no pictures in the
camera or on the card. None required.
To enable Transfer:
1 Connect photo printer to computer
(
page 19 ).
2 Take pictures.
3 Connect the camera or compatible
USB device (
page 8 ).
The camera or compatible
USB device is not connected,
or a card is not inserted.
The photo printer is not
connected to the computer.
The photo printer is printing
in standalone mode. The Transfer button is disabled.
The computer is off. Turn on the computer.
USB device connector light
Light status Cause Action/solution
Light blinks green Slow blink: the device is
initializing or communicating
with the printer. None required.
Fast blink: there is a device or
communication error. Check the USB connections from the
device to the printer.
Disconnect then reconnect USB cable
from printer to device.
Transfer button/light
Light status Cause Action/solution