Kodak ESP 7 - Manual (Page 22)

Printer Overview
14 www.kodak.com/go/aiosupport
Status lights
The tables below describe the meaning of each light and condition, and offer tips on
what action to take.
a
Most power supplies used with this printer are equipped with a status light which illuminates
when electricity is applied. If you cannot determine if the power supply is working properly, contact
Kodak Service & Support for assistance.
On/Off Lights
Light Status Cause Action/Solution
Off The printer is turned off. Press On/Off to turn the printer on.
The printer does not have
power applied. Ensure that the printer power cord is properly plugged into
the back of the printer.
Verify that the power supply and/or power cord LED is lit.
Check that the power supply is connected to the power
cord, and that it is properly connected to the electrical
outlet.
a
Blinks The printer is initializing or
busy. None. Allow the printer to finish the initialization process.
On The printer is ready. None.
Printer Power Cord Light
Light Status Cause Action/Solution
Off The printer power cord is not
properly connected to the printer. Reconnect the printer power cord plug to the printer.
The electrical power cord is not
properly connected to your
electrical outlet. Reconnect the cord to the electrical outlet. Ensure
that the electrical power cord is fully connected to
the alternating current (AC) adapter at the end of
the printer power cord.
The electrical outlet has no power. Plug a working device into the wall outlet to test it,
or have it checked by an electrician.
The problem may lie with the power
supply. Check the power supply status light, if available. As
needed, visit Kodak.com for additional
troubleshooting steps, or contact Kodak Service &
Support.
On The power supply is supplying
power to the printer. None.