Loading plain paper – Kodak ESP 7 User Manual
Page 41
www.kodak.com/go/aiosupport
33
KODAK ESP 7 All-in-One Printer
• If the paper you use is longer than A4 size, including Legal and panoramic
photo paper, make sure that the hinged end of the paper stop lays flat and is
NOT pulled up. The longer paper should balance on the paper output tray
without sliding off.
CAUTION:
This is crucially important when you are printing two or more sheets of long
paper. Long paper that cannot extend straight to its full length when output
from the printer can fold behind the object ahead of it. The curl can result in a
job that dissatisfies you, and it can also causes a blockade preventing paper
still being printed from exiting the printer properly.
Although a paper curl should not interrupt a job involving just one sheet of
long paper, when a sheet’s clean exit from the printer is impeded because the
sheet before it is curled by the paper stop, the current sheet also curls upon
itself, generally behind rather than atop the sheet that came before. This
process repeats until the trapped sheets jam the paper inside the printer.
Loading plain paper
above.
1. Pull the bottom paper tray toward you.
NOTE: To load media that is more than A4 size, such as 4X12 inch panoramic photo
paper or Legal plain paper, you must first extend the lower paper tray to its
full length. To do so:
a. Remove all paper from the tray, as needed.
b. Press and hold the paper tray extension-release, located on the inside of the
front of the lower paper tray.
c. Pull the tray extension toward you gently until it stops moving easily. DO NOT
pull the extension far enough to disengage from the paper tray.
d. Let go of the tray release, and then load the paper in the tray.
2. As needed, squeeze and slide the paper edge guide on the tray to the left so that
it does not block the paper from laying flat.
To return the lower paper tray to its default size, press and hold the
extension-release and push the tray until the extension stops moving,
and then let go.
Tip: