Kodak ESP 7 - Manual (Page 74)

Maintaining Your Printer
66 www.kodak.com/go/aiosupport
Upgrading the printer software - for Macintosh
You can upgrade the software and firmware for in your printer with the most recent
release available. This requires an Internet connection.
NOTE: The firmware cannot be upgraded when your printer is connected via a
network or Wi-Fi. Your All-in-One printer must be connected to the
computer with a USB cable in order to perform a firmware upgrade.
1. If your connection is via Ethernet, disconnect the Ethernet cable. If your
connection is via Wi-Fi, press Menu . Navigate to Network Settings menu and
press OK . Select WIFI Radio off .
2. Connect the printer to the computer with a USB cable. The computer must be
connected to the internet.
3. Open a browser window and enter the following URL:
http://www.kodak.com/go/aiosupport.
4. Select your printer model.
5. Under Downloads , select Software Driver and Firmware Downloads .
6. Select your operating system from the drop down list.
7. Download the software.
8. Double-click on the *.dmg file.
9. Double-click on Install Software .
10. Follow the onscreen prompts on the installer.
11. Upon completion of the install, click Restart . The Home Center Software and the
printer and scanner drivers are updated.
12. Next you will update printer firmware.
13. Open a browser window and enter the following URL:
http://www.kodak.com/go/aiosupport.
14. Select your printer model.
15. Under Downloads , select Software Driver and Firmware Downloads .
16. Select your operating system from the drop down list.
17. Download the firmware.
18. Double-click on the *.dmg file.
19. Double-click on Kodak AiO Updater .
20. Upon completion of the install, click Quit . The printer firmware is updated.