Lenovo ThinkVantage Rescue and Recovery 4.3 (Deployment Guide) - Manual (Page 28)

Table 11. Switches (continued)
Switch Description
/SILENT Suppresses any message boxes for error or
successful completion. (For return codes, the
following table.)
/BOOTSP Takes an explicit Y or N value to indicate
whether the service partition should be set
active. For example, /BOOTSP=Y. A value of
N allows the adminitrator to reset the C:
partition active again, so recovery doesn’t
automatically occur on next reboot.
The executable returns the following codes:
Table 12. Return codes
Return code Return message
0 Success
1 Unable to access service partition.
2 Error copying manifest file into service
partition
3 Error copying personalization file into
service partition
4 Error deleting file from service partition
5 Error writing AUTO.TAG file in service
partition
6 Error setting service partition active
Backups
The following sections provide customization information for Rescue and Recovery
backups.
Scheduling backups and associated tasks
The scheduler is not designed to be specific to the Rescue and Recovery program;
however, the configuration is stored in the registry. When the Rescue and Recovery
program is installed, it will populate the scheduler with the appropriate settings.
Here is a description of the structure for the scheduler:
v Location: Install folder.
v Entry for each scheduled task.
v Script to run.
v Named pipe to be used for progress notifications. This is an optional setting.
v Schedule information monthly, weekly, daily, weekday, or weekend - multiple
schedules. Tuesdays and Fridays for example, can be supported by creating two
schedules.
v Parameters to pass to tasks.
For the Rescue and Recovery program, perform incremental backups on schedule,
with callbacks before and after the backup.
20 Rescue and Recovery 4.3 Deployment Guide