Lenovo ThinkVantage Rescue and Recovery 4.3 (Deployment Guide) - Manual (Page 87)

Table 33. \Rescue and Recovery\Settings\Backup (continued)
Policy Setting Description
MaxNumberIncrementals The maximum number of allowable
incremental backups. Valid values: 2-31.
Default: 3.
Note:
If you have completed backup number
3 and proceed to complete backup number 4
and encounter a message that states: You have
reached your defined limit of 3 incremental
backups. You may increase the maximum number
of incremental backups allowed or the oldest
incremental backup will be deleted. This message
is to let you know that the oldest incremental
backup will be deleted, and will be merged to
the next incremental backup.
ResumeAfterPowerLoss Enable or disable Resume After Power Loss
as a backup option. Default: Enabled.
CPUPriority CPU Priority of backups. Values: 1-5
(1=Lowest Priority, 5= Highest Priority).
Default: 3.
Yield Yield indicates amount of delay to insert
between disk writes during a backup. This
permits system backups from hogging all of
the disk i/o bandwidth. Values: 0-8 (0=off,
8=least disk activity). Default: 0.
BootDisc Enable or disable the creation of a Boot Disc
when backing up to a CD/DVD or creating an
archive to those media. Default: Enabled.
VerifyDisc Enable or disable Verify Disc when backing
up to a CD/DVD or creating an archive to
those media. Default: Enabled.
BatteryPercentRequired Battery Percent Required is essential before
commencing a scheduled backup. This policy
ensures there is enough battery power left to
complete a backup. Values: 0-100. Default: 0.
SkipLockedFiles Enable or disable Skip Locked Files when
backing up. If enabled, locked files will not be
backed up. Default: Disabled.
MinPercentFreeSpace The minimum percentage of free space on the
destination drive required for backup. Values:
0-100. Default: 0.
ProtectWithPassword Enable or disable the Protect With Password
option. If enabled, backups will be protected
with a password. Default: Disabled.
RequiredGBFreeSpace Set the amount of free space in GB that is
required for a backup to occur.
AutosyncRetryNetwork Number of minutes before the user will be
prompted again after the user chooses not to
retry an auto-synchronization to Network.
Prebackup is used when the user wants to run any applications or script before the Rescue and Recovery program
starting a backup.
Appendix A. Administrative tools 79