Lenovo ThinkVantage Rescue and Recovery 4.3 (Deployment Guide) - Manual (Page 54)

8. Put the file back by using the RRUTIL process as described in “Using
RRUTIL.EXE” on page 30.
9. Restart the Rescue and Recovery workspace for changes to be effective.
Adding a static IP address
To add a Static IP address, complete the following steps:.
1.
Get the \MININT\SYSTEM32 winbom.ini file by using the RRUTIL process
described in “Using RRUTIL.EXE” on page 30.
2. Open the file for editing.
3. Add [WinPE.Net] section before [PnPDriverUpdate] in winbom.ini file. For
example, consider the following file: winbom.ini
[Factory]
WinBOMType=WinPE
Reseal=No
[WinPE]
Restart=No
[PnPDriverUpdate]
[PnPDrivers]
[NetCards]
[UpdateInis]
[FactoryRunOnce]
[Branding]
[AppPreInstall]
You must add the following lines to the [WinPE.Net] section.
[WinPE.Net]
Gateway=9.44.72.1
IPConfig =9.44.72.36
StartNet=Yes
SubnetMask=255.255.255.128
4. Get the \PREBOOT\SWWORK NETSTART.TBI file by using the RRUTIL
process described in “Using RRUTIL.EXE” on page 30.
5. Change
factory -minint
to
factory -winpe
6. Comment out the following lines:
regsvr32 /s netcfgx.dll
netcfg -v -winpe
net start dhcp
net start nla
7. Put the \SWWORK\ NETSTART.TBI and \MININT\SYSTEM32 winbom.ini
files back by using the RRUTIL process described in “Using RRUTIL.EXE” on
page 30.
Note: The default environment supports only the DHCP environment.
46 Rescue and Recovery 4.3 Deployment Guide