Lenovo ThinkServer Storage SA120 - Manual (Page 49)

Note: Do not touch the circuit board on the drive.
4. Do one of the following:
• If you are replacing a drive, remove the four screws to remove the failing drive from the drive tray.
Figure 22. Removing the drive from the drive tray
• If you are installing a drive, go to the next step.
5. Align the holes in the drive tray with the corresponding ones on the new drive. Then, install the four
screws to secure the drive to the drive tray.
Figure 23. Installing the drive to the drive tray
6. Slide the assembled drive and tray into the drive bay from the front until the assembly snaps into
position and then completely close the handle.
Chapter 6 . Installing, removing, or replacing hardware 37