Lenovo ThinkStation D20 - Manual (Page 24)

8. Locate an available optical drive connector on the system board. See “Identifying parts on the system
board” on page 8.
9. Using the signal cable that came with the new drive, connect one end of the signal cable to the drive
and the other end to the available optical drive connector on the system board.
10. Locate one of the extra five-wire power cables and connect it to the drive.
Figure 12. Connecting the drive
What to do next:
• To work with another option, go to the appropriate section.
• To complete the installation, go to Chapter 4 “Completing the parts replacement” on page 45.
Installing a diskette drive or card reader in bay 4
To install a diskette drive or card reader in bay 4:
1. Remove the computer cover. See “Removing the computer cover” on page 11.
2. Remove the front bezel. See “Removing the front bezel” on page 12.
3. Remove the plastic panel in the bezel by squeezing the plastic tabs that secure the panel on the inside
of the bezel.
Note: There is a drive retainer bracket for each drive on the inside of the front bezel where the drive is to
be located. Remove the drive retainer bracket and use it to install the drive.
4. Install the retainer bracket on the diskette drive or card reader.
Figure 13. Installing the retainer bracket
5. Remove the static shield from the computer chassis.
18 ThinkStation Hardware Installation and Replacement Guide