Lenovo ThinkStation D20 - Manual (Page 42)

This section provides instructions on how to replace the diskette drive or card reader.
To replace the diskette drive or card reader:
1. Remove the computer cover. See “Removing the computer cover” on page 11.
2. Remove the front bezel. See “Removing the front bezel” on page 12.
3. Locate the diskette drive or card reader. See “Locating components” on page 7.
4. Disconnect the signal and power cables from the rear of the diskette drive. If you are replacing a
card reader, disconnect the card reader cable from the system board. See “Identifying parts on the
system board” on page 8.
5. Press the drive latch 1 and slide the diskette drive or card reader out the front of the chassis.
Figure 37. Removing the diskette drive or card reader
6. Remove the retainer bracket from the failing diskette drive or card reader and install it on the new
diskette drive or card reader.
Figure 38. Installing the retainer bracket
7. Slide the new diskette drive or card reader into the drive bay until it snaps into position.
8. Connect the signal cable and power cable to the new diskette drive. If you are installing a card reader,
connect the card reader cable to the card reader connector on the system board. See “Identifying
parts on the system board” on page 8.
36 ThinkStation Hardware Installation and Replacement Guide