Lenovo ThinkServer RD540 - Manual (Page 33)

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 15
4. On the Please Wait window, wait while the QLogic Adapter vCenter Plug-in is configured for your
system.
5. On the Choose Install Folder window, either accept the default installation directory, or click Choose to
specify a different folder.
6. Click Install to install files to the installation directory specified in the previous step.
A progress window shows the status of the installation.
7. On the User Input window, type your vCenter Server IP address, username, and password, as well as
the IP address of your local Tomcat Server. Then click Next to continue.
8. On the Please Wait window, wait while the QLogic Adapter vCenter Plug-in is configured for your
system and registers the plug-in with the vCenter Server.
9. On the Registration Result window, click Finish to complete the plug-in installation.
Plug-in Unregistration from a Manual Installation
If you have performed a manual installation of the vCenter plug-in, you must perform a manual uninstall
before running the vCenter installation wizard.
VMware provides two type of scripts for vCenter plug-in registration:
• For Windows PowerShell ® scripting: http://communities.vmware.com/docs/DOC-4521
• For Perl: http://communities.vmware.com/docs/DOC-4530
1. Before you can use the script, download the appropriate VI SDK from VMware.
• For PowerShell, download vSphere PowerCLI:
http://communities.vmware.com/community/vmtn/vsphere/automationtools/powercli
• For Perl VI SDK, download vSphere SDK for Perl:
http://www.vmware.com/support/developer/viperltoolkit/
2. After you download and install the SDK and the registration script, follow the VMware instructions to
register the vCenter Plug-in.
For example, the Perl unregister command is:
perl registerPlugin.pl --server="127.0.0.1" -username="administrator"
--password="password" --key="com.qlogic.QLogicAdapterVIPlugIn" --action="remove"
3. Replace the username and password with the correct information to log into the vCenter Server.
Launching the Plug-in from vSphere Client
To launch the plug-in from vSphere client:
1. Start the vSphere Client and connect to the vCenter Server. (If you start and connect the vSphere Client
directly to an ESX or ESXi server, the vCenter plug-in does not appear.)
2. If you have not done so, create a data center and add the ESX server.
3. In the left pane, select the server.
A row of tabs appear in the right pane. If the server has QLogic Adapter CIM Provider and adapters
installed, and if the vCenter plug-in installation and registration were successful, the QLogic Adapter
tab appears in the tab row.
4. Click the QLogic Adapter tab to view a web page.