Lenovo IdeaCentre K210 - Manual (Page 26)

23
Hardware Replacement Guide
3. Disconnect the signal and power cables from the rear of the optical drive.
4. Press the release button and remove the optical drive out the front of the
computer.
5. Slide the new optical drive into the bay from the front until it snap into position.
6. Connect the signal and power cables to the drive.
7. Install the front bezel. Refer to “Removing and replacing the front bezel”.
8. Refer to the “Completing the installation”.
Replacing the system fan assembly
Attention
Do not remove the computer cover or attempt any repair before reading the
“Important safety information” in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM
, go to the Support Web site at http://www.lenovo.com/support.
31032753 IdeaCentre K_HRG_EN.indd 23 2007.12.10 3:53:29 PM