Lenovo IdeaCentre K210 - Manual (Page 30)

27
Hardware Replacement Guide
4. Disconnect the failing mouse cable from the computer.
5. Connect the new mouse cable to the connector.
6. Refer to the “Completing the installation.”
Replacing the External speaker
1. Remove any media (diskettes, CDs, or tapes) from the drives, shut down the
computer, and turn off all attached devices.
2. Unplug all power cords from electrical outlets.
3. Locate the Speaker. Refer to “Locating connectors on the rear of the
computer” and “Locating connectors on the front of the computer”. Your
speaker might be connected to the Audio connector to an Audio connector
at either the front or rear of the computer. Locate the connector for the
speaker.
4. Disconnect the failing speaker cable from the computer and connect the new
speaker cable to the same connector.
5. Refer to the “Completing the parts replacement”.
Completing the installation
After replacing the parts, you need to close the computer cover and reconnect
cables, including telephone lines and power cords. Also, depending on the part
that was replaced, you might need to confirm the updated information in the Setup
Utility program. Refer to “Starting the Setup Utility” in the User Guide or in the
Hardware Maintenance Manual
.
31032753 IdeaCentre K_HRG_EN.indd 27 2007.12.10 3:53:33 PM