AT&T E2801 - Manual (Page 10)

7
Getting started
Battery installation & charging
After installing the battery, you may be able to make and receive short calls.
For best performance, place the handset in the telephone base and charge for
16 hours before use.
You can keep the battery charged by returning the handset to the telephone
base after use. When the battery is fully depleted, a recharge takes about 12
hours. The average talk time on a fully charged battery is about eight hours and
and
the standby time is approximately five days. Actual battery life depends on usage time is approximately five days. Actual battery life depends on usage
conditions and age of battery.
4. You may be able
to make and receive
short calls. For best
performance, place the
handset in telephone
base to charge for at
lease 16 hours before
first use.
1. Insert the plug as indi-
cated. Be sure to securely
insert the plug, making
sure it matches the color-
coded label inside the bat-
tery compartment.
3. Slide the battery
compartment cover up
until it clicks. 2. Place the battery
and wires inside the
compartment.
Low battery indicator
Return the handset to
the telephone base
to recharge when
this symbol flashes.
(Handset will beep
when battery is low.)
To replace the battery, press in and downward on the tab of the
battery compartment cover to open the battery compartment
cover. Lift out the old battery and disconnect it from the hand-
set. Follow the instructions on this page to install and charge
the new battery.
LOW BATTERY
Caution: Use only the supplied rechargeable battery or replacement battery (model 27910,
part number 89-0099-00-00) or equivalent. To order a replacement battery, visit our website at
www.telephones.att.com or call 1 (800) 222-3111; in Canada, call 1 (866) 288-4268.
NOTE: Under normal conditions, the battery should
last around one year. This may vary depending on usage.