AT&T E2801 - Manual (Page 12)

9
Getting started
3. To attach the bracket for wall mounting,
insert the tabs of the bracket into slots
and on the telephone base, then press
the other bracket tabs into slots and
as shown on the right.
4. Plug the power adapter into an electrical
outlet not controlled by a wall switch. Plug
the telephone line cord into a telephone
wall jack. To mount the telephone on the
wall, position the mounting holes and
over the telephone outlet mounting studs.
Press and slide the bracket down firmly so
the telephone is held securely on the tel-
ephone outlet mounting studs.
Telephone outlet mounting studs
Installation options
Tabletop mounting
To return the bracket from the wall mount to tabletop position, follow the
directions below.
1. Remove the telephone base from the wall.
Unplug the cords from the wall jacks.
Remove the bracket from the telephone
base.
2. Insert the bracket tabs into slots
and on the telephone base,
then press the other bracket
tabs into slots
and .
3. Route cords through slots. Plug the
other end of the telephone line cord
into a telephone wall jack. Plug the
large end of the power adapter into
an electrical outlet not controlled by
a wall switch.