Alliance Laundry Systems UW35B2 - Manual (Page 11)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
9 F232168
Options for Each Segment
† Normal Agitation is 12 seconds forward, 3 seconds
off, 12 seconds reverse, 3 seconds off, and repeat.
†† Gentle Agitation is 3 seconds forward, 12 seconds
off, 3 seconds reverse, 12 seconds off, and repeat.
††† Extra Fill (“EFIL”) possible only if configured for
“EFIL” in Setup Mode.
†††† ADD BLEACH LED lights if Supply 2 is the only
supply programmed and if set up for “bEEP” (refer
to Setup Mode section). ADD BLEACH LED and
Supply 2 signal are on for up to 45 seconds, or until
the programmed water level is reached, whichever
occurs first. If “bEEP” is enabled, beeper begins
beeping when Supply 2 comes on and beeps for 8
seconds.
††††† Appears only if “ESUP” (extra supply) configured
in Setup Mode.
Cycle Steps Available
(NOTE: WASH, ADD BLEACH, RINSE, and SPIN
LEDs light ONLY when a cycle formula is in
operation.)
Setting Options for Cycle Steps
(Press START key to advance to next row selection,
(
∧
) to increase a value or change, (
∨
) to decrease a
value or change, or (
∗)
to save and exit.)
Agitation in effect for cycle Normal† or Gentle†† agitation
Wash 1 (displayed as “USH1”), lights WASH LED (during operation)
Time for agitation (excludes fill, drain, spin, heat) 0 or 2-30 minutes (one-minute increments)
Fill valves (temperature) Cold, Hot, Warm (Cold & Hot) or “EFIL”†††
Fill water level control Low, Medium, or High
Supply None (0), 1, 2 (liquid bleach††††), 3, 4, 5†††††, 6 (1 and 2
together displays as “SUP6”), or 7††††† (Supply 4 and extra
supply 5 together displays as “SUP7”).
Heat (appears ONLY for models with heat capability) 00F (no heat for segment), or 80°F to 205°F
00C (no heat for segment), or 27°C to 95°C
Drain (Select Drain or No Drain. Final segment drains in
stop routine if No Drain is programmed.) Drain or No Drain (if No Drain, skips the spin step which
automatically sets that spin time = 0)
Spin time 0 or 30-240 seconds (one-second increments)
Wash 2 (displayed as “USH2”), lights WASH LED (during operation)
Time for agitation (excludes fill, drain, spin, heat) 0 or 2-20 minutes (one-minute increments)
Fill valves (temperature) Cold, Hot, Warm (Cold & Hot) or “EFIL”†††
Fill water level Low, Medium, or High
Supply None (0), 1, 2 (liquid bleach††††), 3, 4, 5†††††, 6 (1 and 2
together displays as “SUP6”), or 7††††† (Supply 4 and extra
supply 5 together displays as “SUP7”).
Heat (appears ONLY for models with heat capability) 00F (no heat for segment), or 80°F to 205°F
00C (no heat for segment), or 27°C to 95°C
Drain (Select Drain or No Drain. Final segment drains in
stop routine if No Drain is programmed.) Drain or No Drain (if No Drain, skips the spin step which
automatically sets that spin time = 0)
Spin time 0 or 30-240 seconds (one-second increments)
Table 1 (Continued)