Alliance Laundry Systems UW35B2 - Manual (Page 9)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
7 F232168
Setup Mode (For Earlier Models)
NOTE: In Setup Mode, certain machine functions
can be configured. The settings in this mode are
related to how the machine is equipped from the
factory. Usually, these would not be changed in this
field.
NOTE: Enter Setup Mode through the Program
Mode.
1. Press (*) key. Display will show “FAr” or “CEL”.
NOTE: This selects whether temperatures display
in degrees Fahrenheit (F) or Celsius (C), if control
is equipped with a temperature sensor. Press the
(
∧
) or (
∨
) key to change.
NOTE: Changing degrees “FAr” or “CEL” only
has an effect if the control has a temperature probe
connected and/or heat capability.
2. Press START key.
3. Model will display “HEAt” or “noHt”. Change
the selection by pressing the (
∧) or (∨) key.
4. Press START key to continue to the next step.
NOTE: If set for “HEAt”, the control has heat
capability enabled. The washer-extractor MUST
have electric or steam heat, and a temperature
probe. If display shows “noHt”, or if the message
“HEAt” or “noHt” does NOT display, the control
does NOT have heat capability.
5. Certain models will display “EFIL” or “ESUP”.
For these models, the control provides a spare
output (for certain models). The spare output can
be set up to control an extra fill valve (“EFIL”),
with the ability to fill to a programmable water
level (just as for regular fills), OR the spare
output can be set up to control an extra chemical
supply signal (“ESUP”).
6. Press START keypad.
7. Certain models display “bEEP” (control sounds
beeper during Add Bleach [Supply 2]) or “nobP”
(control does NOT sound beeper during Add
Bleach [Supply 2]). Change selection by pressing
(
∧) or (∨) keypad.
8. Press START keypad.
NOTE: If “EFIL” or “ESUP” does NOT display,
the extra fill capability is NOT present. If either
message does display, change the selection by
pressing the (
∧
) or (
∨
) key. Press START key to
return to Program Mode. Refer to “Programming
Cycle Segments” section for additional information.
Cycle and Error Count
The control logs cycle count (total of all cycles
completed).
● To read, enter Program Mode.
● Press START (enter) key. Display will show the
cycle count.
● Press START (enter) key. Display will show
certain error conditions that may have been
recorded by the control.
● Read the information when consulting technical
assistance as needed.
● Step through the error log by pressing START
key repeatedly until display reverts to normal
Program Mode (showing a temperature).