Alliance Laundry Systems UW35B2 - Manual (Page 7)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 5 F232168
Programming
NOTE: The machines are factory-programmed
with basic cycles to make the units operational
without programming at the installation.
Entering Program Mode
1. Open control compartment lid.
2. Locate Program/Run switch on the computer
board. (This is accessed through a cutout in the
metal control unit cover.) This switch protrudes
from the rear of the electronic control unit cover.
3. Flip switch to the left (as seen from the front of
machine) to enter Program Mode.
4. Display will show a temperature.
Determining Firmware ID Code
1. Turn on the main power source (circuit breaker or
cut-off switch on wall).
2. Display will show Firmware ID code (i.e.,
“o2UC” and “ouUC” etc...).
3. Record Firmware ID Code for future reference.