Lenovo ThinkServer RD650 - Manual (Page 153)

Note: Do not touch the circuit board on the solid-state drive.
5. Position the 2.5-inch solid-state drive into the 3.5-inch to 2.5-inch drive adapter as shown in the
following illustration.
Figure 120. Positioning the 2.5-inch solid-state drive into the drive adapter
6. Align the two screw holes in the solid-state drive with the corresponding holes in the drive adapter.
Then, install the two screws to secure the solid-state drive to the drive adapter.
Figure 121. Installing the screws to secure the solid-state drive to the drive adapter
Chapter 6 . Replacing hardware 139