Lenovo ThinkServer RD650 - Manual (Page 98)

6. Disconnect any cables that might impede your access to the memory slots.
7. Open the retaining clips of the appropriate memory slot.
Figure 51. Opening the retaining clips of the memory slot
8. Touch the static-protective package that contains the new memory module to any unpainted surface on
the outside of the server. Then, take the new memory module out of the package.
Note: Carefully handle the memory module by its edges.
9. Position the new memory module over the memory slot. Ensure that the notch 1 on the new memory
module is aligned with the key 2 in the memory slot. Then, press the new memory module straight down
into the memory slot until the retaining clips close and the new memory module snaps into position.
Note: If there is a gap between the memory module and the retaining clips, the memory module has
not been correctly installed. Open the retaining clips, remove the memory module, and then reinstall it
into the memory slot until the retaining clips are completely closed.
Figure 52. Installing a memory module
10. Reconnect any cables that you have disconnected.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 183.
84 ThinkServer RD650 User Guide and Hardware Maintenance Manual