Konica Minolta bizhub 4050 - Manual (Page 48)

[Maintenance/Troubleshooting] 4-15
4.7 Major messages and actions 4
4.7 Major messages and actions
Check the displayed message, then take the appropriate action. If messages other than those listed below
have been displayed, follow them to perform processing.
Warning messages
Error messages
Message Description Remedy
[Memory Overflow] Not enough memory to print on a
copy basis. Print only the first page.
[HDD is low on disk space.] The HDD free space is insuffi-
cient. Delete data saved on the HDD, if
necessary.
[Paper Empty] No paper is loaded in the tray. Add paper.
[Toner is low.] The toner is about to run out. Prepare the specified Toner Car-
tridge.
[Replace toner] Toner is depleted. Replace the Toner Cartridge.
For details, refer to page 2-3.
[Imaging Unit will require re-
placement soon.] The operating life of the Imaging
Unit has expired. Replace the Imaging Unit.
For details, refer to page 2-5.
[Maintenance Kit will require
replacement soon.] The maintenance kit has expired. Replace the maintenance kit.
For details, contact your service rep-
resentative.
[Incorrect HDD] An incorrect HDD has been in-
stalled. Select [Utility] - [Administrator Set-
tings] - [Security Settings] - [HDD
Settings], then format the HDD.
[Replace Staples] Staples have run out. Replace the staple case.
For details, refer to page 2-7.
[Exceeds the no. of pages
being stapled.] An attempt was made to print
over the maximum number of
sheets of paper that could be
stapled. Cancel the job, or release the staple
setting.
[The USB device is invalid.] An incompatible USB device has
been connected to the USB port. Disconnect the USB device.
[IEEE 802.1x Authentication
failure.] IEEE802.1X authentication has
not been executed normally,
causing a timeout. Restart this machine.
[IEEE802.1x Authenticating] IEEE802.1X authentication is
currently executed. Wait until authentication is complet-
ed.
[Fax Memory Low] The fax data storage area is in-
sufficient. Check fax jobs. Delete fax jobs, if
necessary.
[Fax RX Job Max Over] The number of registered fax RX
jobs has reached the upper limit. Print or cancel fax RX jobs.
Message Description Remedy
[Configuration of options has
been changed.] The option configuration was
changed while the power was
turned on. Restart this machine.
[There is an open compo-
nent.] The cover is opened. Close the cover.
[Paper Jam] A paper jam has occurred. Check a paper jam location, then re-
move the jammed paper.
[Staple Jam] A staple jam has occurred. Open the cover in the right-hand
side of the Finisher, then remove the
jammed staples.
For details, refer to page 3-15.