Konica Minolta bizhub 4050 - Manual (Page 11)

1.4 Safety information 1
[Introduction] 1-7
Grounding
WARNING
• Make sure to ground this product. (Connect the power cord to an electri-
cal outlet that is equipped with a grounding terminal.) Failure to do so and
an unlikely event of leakage could result in a fire or electrical shock.
Installation
WARNING
• Do not place a flower vase or other container that contains water, or metal
clips or other small metallic objects on this product. Spilled water or me-
tallic objects dropped inside the product could result in a fire, electrical
shock, or breakdown.
Should a piece of metal, water, or any other similar foreign matter get in-
side the product, immediately turn OFF the power switch, unplug the
power cord from the power outlet, and then call your authorized service
representative.
• Do not use flammable sprays, liquids, or gases inside or near this ma-
chine. Do not clean the inside of this machine using a flammable gas
duster. A fire or explosion could result.
CAUTION
• After installing this product, mount it on a secure base. If the unit moves
or falls, it may cause personal injury.
• Do not place the product in a dusty place, or a site exposed to soot or
steam, near a kitchen table, bath, or a humidifier. A fire, electrical shock,
or breakdown could result.
• Do not place this product on an unstable or tilted bench, or in a location
subject to a lot of vibration and shock. It could drop or fall, causing per-
sonal injury or mechanical breakdown.
• Do not let any object plug the ventilation holes of this product. Heat could
accumulate inside the product, resulting in a fire or malfunction.
Ventilation
CAUTION
• Using this product in a poorly ventilated room for a long time or producing
a large volume of copies or prints may cause the odor of exhaust air from
the machine. Ventilate the room well.