Konica Minolta bizhub C20X - Manual (Page 306)

Status, Error, and Service Messages 292
MEMORY FULL
The machine has
received more data
than can be pro-
cessed with its inter-
nal memory. Turn the machine off,
and then, after a few
seconds, turn it on
again. Decrease the
amount of data to be
printed (for example,
by decreasing the res-
olution), and then try
printing again.
NO DUPLEX PAPER
CLOSE DUPLEX FUNC.
OR CHANGE PAPER SIZE
Duplex (dou-
ble-sided) printing is
specified, but paper
with a size incom-
patible with duplex
(double-sided) print-
ing is selected. Switch to simplex (sin-
gle-sided) printing, or
select paper with a size
compatible with duplex
(double-sided) printing.
NO NETWORK SETTING
The network set-
tings had not been
completely specified
when the machine
was switched to
Scan mode. Before scanning in
Scan mode, specify
the network settings in
the NETWORK SET-
TING and E-MAIL
SETTING menus.
NO SUITABLE PAPER
LOAD PAPER (xxx)
Paper suitable for
printing is not
loaded in a paper
tray. Load paper suitable for
printing into a paper
tray.
NON SUPPORT
MEMORY CARD
A CompactFlash
card not supported
by this machine is
installed. Install a
CompactFlash card
supported by this
machine.
NOT E-MAIL ADDRESS
When the destina-
tion for the scan
data was specified,
a fax number regis-
tered in the favorite
list or as a speed
dial destination or
group dial destina-
tion has been
selected. Directly type in the
destination for the scan
data, or specify an
e-mail address regis-
tered in the favorite list
or as a speed dial des-
tination or group dial
destination.
This message... means... Do this...