Konica Minolta bizhub C20X - Manual (Page 49)

Configuration Menu Overview 35
KEY
SPEED
TIME TO
START
Setting
0.1sec / 0.3sec / 0.5sec /
1.0sec / 1.5sec / 2.0sec /
2.5sec / 3.0sec
Specify the length of time until the cursor begins
to move continuously when a key is held down.
INTERVAL
Setting
0.1sec / 0.3sec / 0.5sec /
1.0sec / 1.5sec / 2.0sec /
2.5sec / 3.0sec
Specify the length of time until the cursor contin-
uously moves between settings or characters.
LANGUAGE
Setting
ENGLISH / FRENCH / GERMAN /
ITALIAN / SPANISH / PORTU-
GUESE / RUSSIAN / CZECH /
SLOVAK / HUNGARIAN / POLISH
Select the language of the menus and mes-
sages that appear in the message window.
LAMP OFF TIME
Setting
MODE1 / MODE2
Select the length of time until the scanner unit
lamp goes off when no operation is performed.
If
MODE1
is selected, the lamp goes off when
the machine enters Preheat mode.
If MODE2 is selected, the lamp goes off when
the machine enters Energy Save mode.
LAMP WARMUP TIME
Setting
AUTO / FIX
Specify the warm-up time for the lamp of the
scanner unit.
If AUTO is selected, the length of time to
recover from Energy Save mode when the
machine is turned on is adjusted according to
the room temperature. Since the machine can-
not be used until its condition is completely sta-
bilized, select this setting, for example, if you
wish to scan at a high image quality from the
first page.
If FIX is selected, the machine can be used
after lamp warm-up is finished. With a low room
temperature, the quality of the first page of a
copy or scanned image may not be as good as
if
AUTO was selected.