Konica Minolta bizhub 282 - Manual (Page 246)

Specifying management settings 7
362/350/282/250/222/200 7-15
Sp
ecif
yin
g
man
age
men
t
set
ti
ngs
Chapter 7
– To specify the hex value, touch [HEX Selection], use the keypad or
touch [A] through [F] to specify the value, and then touch [Enter].
5
To change the setting for a different mode, repeat steps 3 and 4.
6
Touch [Enter] in each screen until the initial screen appears.
7
Turn the machine off, then on again.
2
Reminder
When turning the machine off, then on again with the main power switch,
wait about 10 seconds to turn the machine on after turning it off. The ma-
chine may not operate correctly if it is turned on immediately after being
turned off.
Soft SW Setting
Enter
000
( 76543210)
00110000
30
Bit Selection
Mode Selection
Enter F
C
E
B
D
A
HEX Selection
100% Memory
Free