Konica Minolta bizhub 282 - Manual (Page 106)

Scan to PC operations 3
362/350/282/250/222/200 3-31
Sca
n
t
o
PC op
er
at
ions
Chapter 3
3.7 Registering a destination
Programming a one-touch dial button
If a recipient is registered with a one-touch dial button, the transmission can
be sent easily and accurately.
Two types of recipients can be registered with a one-touch dial button: a
main recipient and a secondary recipient, where the data is sent if the trans-
mission to the main recipient fails.
2
Note
If “Restrict One-Touch Editing” on the Administrator Set screen (dis-
played from the Administrator Management 1 screen) is set to “ON”, if
software switch settings were specified to limit registration of one-touch
dial buttons to the administrator, or if “Enhance Security” is set to “ON”,
one-touch dial buttons can only be registered, edited or deleted from Ad-
ministrator mode. For details on the settings in Administrator mode, refer
to the User’s Guide [Facsimile Operations]. For details on the software
switch settings, refer to “Specifying software switch settings (machine
functions)” on page 7-12.
!
Detail
Any of the following communication modes can be specified for the sec-
ondary recipient.
- PC (E-Mail)
- PC (Scanner)
- InternetFAX (Internet FAX)
- InternetFAX (IP-TX)
- InternetFAX (IP Relay)
- FAX (G3)*
*
The communication mode can be specified if the optional fax kit is in-
stalled.
2
Note
Certain communication modes may not be available, depending on the
machine settings. For details, check with the administrator.