Konica Minolta bizhub 282 - Manual (Page 269)

8 Troubleshooting
8-6 362/350/282/250/222/200
Tro
uble
s
hoo
tin
g
Chapter 8
8.3 Troubleshooting
Remedies for several possible problems are described below.
IP address faxing
Scan to PC operations
Problem Cause Remedy
Transmission is not
possible. The connections are incor-
rect. Check the LED indicator on the hub
and check the connections.
Since the image data is too
large, a timeout occurred at
the receiving end. • Increase the timeout setting on the
receiving end.
• Decrease the size of the image data,
and then try transmitting again.
The settings necessary for the
device are not registered. Specify the necessary network set-
tings.
The LAN cable is damaged. Replace the LAN cable.
IP has been limited with IP fil-
tering. Check with the administrator of the
machine.
Other causes Check the list of transmissions in the
Job List screen for details of the trans-
mission error, and then refer to the ta-
ble of error codes.
Problem Cause Remedy
Transmission is not
possible. -------- Check the list of transmissions in the
Job List screen for details of the trans-
mission error, and then refer to the ta-
ble of error codes.
The LAN cable is damaged. Replace the LAN cable.
IP has been limited with IP fil-
tering. Check with the administrator of the
machine.
The data is not re-
ceived by the com-
puter. -------- Check the list of transmissions in the
Job List screen for details of the trans-
mission error, and then refer to the ta-
ble of error codes.