9 start, 10 reset / stop, 11 re-scan – Konica Minolta KIP 2100 Scanner User Manual
Page 100: 12 view last, 13 log off
Section 4 Scan Mode - Monochrome
4-26
2.9 Start
No function at this time in Scan Mode.
All scans in Scan Mode are “Auto Start”.
2.10 Reset / Stop
This button has two functions.
1) Press the Stop button on the UI to stop the current scan. The original
will be ejected automatically. If not, open Top Cover to remove the
original.
2) Press the Reset button to restore the “default settings” in Scan Mode.
Some of the default settings are determined in the Information / Help Screen of the
UI. (see Scan Mode Configurations chapter)
2.11 Re-Scan
If the scanned image was not satisfactory, you can replace the last image
scan by selecting this button and proceeding with the scan procedure as
normal.
2.12 View Last
Allows the last scan to be reviewed again on the UI.
2.13 Log Off
This button may be displayed if accounting is enabled. Press this button to
log off the current user after scanning has been completed.