Konica Minolta KIP 2100 Scanner - Manual (Page 4)

2
WARNING
1. Power source should be rated from 100V to 240V plus or minus 10%,
6A or higher and 50/60Hz.
2. It is preferable that the power circuit is provided on a dedicated
breaker.
3. Install the machine as close as possible to the outlet.
4. When you wish to move the machine to another place, make sure to
ask your service engineer.
Electrically ground the scanner with a ground wire.
Otherwise you may receive an electric shock to include lightning strikes.
If the outlet does not have a Grounding Terminal or if it is impossible to
connect, call the vendor or service professional for installation.
Do not disassemble or tamper the machine. Otherwise, it may cause a fire
or you may receive an electric shock.
1. Do not use a multi-wiring connector that might raise the temperature of
the outlet and cause a fire.
2. Do not put anything heavy on the power cord. It may cause a fire or
you may receive an electric shock.
3. Do not step on the power cord, and do not damage or process it. It
may also cause a fire or you may receive an electric shock.
4. Do not tie the power cord or make a knot on it. It may also cause a fire
or you may receive an electric shock.
5. Do not put a flower vase, a flowerpot or a water-filled containers on the
top of the machine. If the water spills out, it may also cause a fire or
you may receive an electric shock.
1. If the machine generates abnormal smell or noise, turn it off and
disconnect the power plug from the outlet.
2. Do not handle the power plug with the wet hands. It may
cause you may receive an electric shock.
3. Insert the power plug into the outlet completely. If the power plug is not
inserted completely, it may cause a fire.
4. Use only the correct power cord.
Make sure to use the Plug when you unplug the machine.
Otherwise, you may break the cord and may result in a fire or you may
receive an electric shock