Konica Minolta bizhub Secure - Manual (Page 22)

bizhub 652/552 2-7
2.1 Accessing the Administrator Settings 2
5
Select "Administrator (Admin Mode)" or "Administrator (User Mode)" and enter the 8-digit Administrator
Password in the "Password" box.
% If "Administrator (Admin Mode)" is selected, the settings for the machine system and network can
be registered or changed.
% If "Administrator (User Mode)" is selected, you can log on to the User Mode as an Administrator. In
the User Mode, you can check or delete a job, which is disabled in Administrator Settings. Note,
however, that the authority relating to box settings is the same as that of Administrator Settings.
% When accessing the Admin Mode using the PageScope Web Connection, enter the same Adminis-
trator Password as that for the machine.
6
Click [OK].
% If a wrong Administrator Password is entered, a message that tells that the authentication has failed
appears. Enter the correct Administrator Password.
% If the Enhanced Security Mode is set to [ON], entry of a wrong password is counted as unauthorized
access. If a wrong Administrator Password is entered a predetermined number of times (once to
three times) or more set by the Administrator of the machine, a message appears saying that the
machine accepts no more Administrator Passwords because of unauthorized access for any sub-
sequent entry of the Administrator Password. The machine is then set into an access lock state. To
cancel the access lock state, settings must be made by the Service Engineer; or, turn off, and then
turn on, the main power switch of the machine. If the main power switch is turned off and on, the
access lock state is canceled after the lapse of time set for [Release Time Settings]. When the main
power switch is turned off, then on again, wait at least 10 seconds to turn it on after turning it off. If
there is no wait period between turning the main power switch off, then on again, the machine may
not function properly.
Here is the sequence, through which the main power switch and sub power switch are turned on
and off:
Turn off the sub power switch ö Turn off the main power switch ö Turn on the main power switch
ö Turn on the sub power switch
7
Click [Logout].
8
Click [OK].
This allows you to log off from the Admin Mode.