Konica Minolta bizhub 181 - Manual (Page 180)

Advanced copy operations 5
bizhub 181 5-21
Advan
c
e
d
copy ope
ra
tio
n
s
Chap
te
r 5
6
Press the [+] or [,] key until “FRAME ERASE”, “CENTER ERASE” or
“CENTER+FRAME ERASE” is selected, and then press the [OK] key.
– For details on the areas that are erased, refer to “Frame/center
erasing methods” on page 5-22.
– The width of the erased area for the FRAME ERASE setting can be
set between 3/16 inch and 13/16 inch, in Approx.1/16 inch incre-
ments. The manufacturer’s default setting is 3/8 inch.
– The width of the erased area for the CENTER ERASE setting is fixed
at 3/8 inch.
– The width of the erased area for the FRAME ERASE setting can be
changed using the ERASE SETTING parameter in the Utility mode.
(Refer to “Adjusting the width of the erased area (“ERASE SET-
TING” parameter)” on page 6-64.)
“/” appears beside “ERASE” in the COPY FUNCTION menu.
7
Press the [Back] key.
The main screen appears again.
8
If necessary, specify any other copy settings.
– Refer to “Before making copies” on page 3-2.
– Refer to “Advanced copy operations” on page 5-2.
9
Using the keypad, type in the desired number of copies, and then press
the [Start] key.