Konica Minolta bizhub 181 - Manual (Page 222)

Utility mode/Copy mode parameters 6
bizhub 181 6-27
U
tility mode/Copy
mode parameters
Chap
te
r 6
6.5 CUSTOM SIZE MEMORY
From the “CUSTOM SIZE MEMORY” menu, two of the most frequently used
custom paper sizes can be registered. The custom paper sizes registered
here can be selected for the size of paper loaded in the 1st paper drawer by
selecting “PAPER SOURCE SETUP” in Utility mode, then selecting “TRAY1
PAPER”, then “PAPER SIZE”.
CUSTOM SIZE MEMORY options
* When using the 10-Key Pad to enter a measurement, the values are entered in millimeters. The
conversion ratio is shown below.
1 inch = 25.4 mm
Registering a custom paper size
1
Press the [Utility] key.
The “UTILITY MODE”
menu appears.
2
Press the [+] or [,] key until “CUSTOM SIZE MEMORY” is selected,
and then press the [OK] key.
No. CUSTOM SIZE MEMO-
RY Description
1 MEMORY1 Frequently used paper sizes can be registered and recalled
when needed. The following sizes can be registered.
Length: 140 mm to 432 mm*
Width: 90 mm to 297 mm*
2 MEMORY2