Konica Minolta Bizhub 215 - Manual (Page 55)

bizhub 215 6-2
6.1 Basic transmission method 6
6 How to Use Scan to Server
This chapter describes how to transmit scanned data to the server.
Tips
- To use Scan to Server function, Network Card NC-504 or Image Controller IC-209 and Extended
Operation Panel MK-733 must be installed.
6.1 Basic transmission method
This section describes the basic transmission method.
Tips
- To run Scan to Server (FTP/SMB), the FTP/SMB server address has to be registered as a speed dial
number in advance.
- When uploading scanned data onto the server, the user can set whether an E-mail is sent to notify of
successful data unloading. This machine can register ten E-mail addresses.
To inform the other party via E-mail, SMTP server has to be registered in advance.
- To register a server or to set up E-mail notification, access to PageScope WebConnection has to be
set up in the administrator mode. These settings cannot be made through the Control Panel.
d
Reference
For details on accessing PageScope Web Connection in Administrator mode, refer to PageScope Web
Connection in [User's Guide Network Administrator].
For details on registration of the FTP/SMB server address to the speed dial number and setting of information
by E-mail, refer to PageScope Web Connection - [Address] tab - [Speed Dial Setting] in [User's Guide Net-
work Administrator].
For details on setting SMTP server, refer to PageScope Web Connection - [Network] tab - [SMTP & POP3
Configuration] in [User's Guide Network Administrator].
6.1.1 When using the ADF
1
Press the Scan key.
The machine switches to the scan mode.
2
Load the original onto the ADF.
% The maximum number of originals that can be placed at one time into the ADF is 70. Do not set orig-
inals above the , mark.
% For details on the setting direction of the original, refer to [User's Guide Copy Operations].
% For details on how to set a double-sided original, refer to page 6-3.