Konica Minolta KIP 9000 - Manual (Page 34)

Chapter 2 Basic Operations 2-11
2. 3. 2 Roll 4
The way of paper installation to Roll 4 is a little different from the way for other Rolls because of
the different location of Roll 4’s feeding rollers. This section instructs only the operation individually
required for Roll 4. Refer to [2.3.1 Roll 1, 2 & 3] on page 2-5 for the rest of common operations.
1. Draw out the bottom Roll Deck.
2. Remove the Roll Spool from the Roll Deck, pull
out the Roll Spool from the old roll media, and
set the new roll media onto the Roll Spool.
NOTE
Please keep the correct direction as the following left photo.
(It is the same way you make for Roll 1, 2 & 3.)
Correct Wrong