Asante Technologies 1000 - Manual (Page 29)

Configuring Network Access Parameters
Page 4-5
Configuring Network Access Parameters
To configure and/or manage the SuperStack II Switch 1000 over the net-
work or via out-of-band access, the device needs to be properly config-
ured with network access parameters. These parameters are initially
configured in the device via the console port; however some can be
modified using IntraSpection.
To view/configure network access parameters:
1
Do not select any item on the Device Page’s front panel
image. (This selects the entire device.)
2
Click netwAccess.
The Network Access Information table appears, similar to
Figure 4-4.
Figure 4-4 Network Access Information table
3
Click once in the field to be edited.
For a description of each field, see “Network Access “ on
page 6-14.
4
Type the new information or select an option (if it’s a
drop-down menu).
5
Click Apply.
The network access parameters are configured. To view
updated information, click
Refresh.
book Page 5 Thursday, September 4, 1997 3:47 PM