Asante Technologies 1000 - Manual (Page 74)

Menus
Page 6-18
Graph
This menu allows you to view real-time statistical information — in a
graph format — on the SuperStack II Switch 1000, one of its VLAN
groups, or one of its ports.
Table 6-11 describes each field in the Graph menu.
∆
Note: For instructions on using this menu, see “Viewing
Statistics” on page 4-18 or “Viewing Statistics for a VLAN
Group” on page 5-12.
Table 6-11 Graph Menu
Field Description
Seconds Drop-down menu; specifies the amount of time (in
seconds) that the device is polled for information.
Statistics Drop-down menu; determines the object for which
statistics are gathered.
Device Statistics
❏
Readable Frames — displays the total number
of good or readable frames (frames without
error).
❏
Unicast Frames — displays the number of
frames seen by the card that is addressed to a
unicast (non-card) address.
❏
Broadcast Frames — displays the total num-
ber of frames that were successfully received
and were directed to the broadcast group
address.
❏
FCS Errors — displays the number of frames
that failed Cyclic Redundancy Check (CRC).
❏
Alignment Errors — displays the number of
frames that were an integral number of octets
in length and did not pass the FCS check.
❏
FramesTooLong — displays the number of
frames that exceeded 1,518 bytes.
❏
Short Events — displays the number of data
bursts (data less than 10 bytes in length).
❏
Runts — displays the number of frames
shorter than 64 bytes.
❏
TX Collision — displays the total number of
collisions that occurred when transmitting
from the device.
book Page 18 Thursday, September 4, 1997 3:47 PM