AEG DC4003000M - Manual (Page 18)

2. Hold the heating element with the
two hands at the front
3. Pull it forwards against the spring
pressure and out along the support
on both sides.
4. The heating element folds down.
The oven ceiling is ready to clean.
Installing the heating element
1. Install the heating element in oppo-
site sequence.
Install the heating element cor-
rectly on the two sides above the
support on the inner wall of the
oven.
2. Insert shelf support rails.
9.3 Door and glass panels
Remove the door to clean it.
A
A
Removing the door
CAUTION!
Be careful when you remove the
door from the appliance. The
door is heavy.
1. Open the door as far as it goes.
2. Fully lift up the clamping levers (A)
on the two door hinges.
45°
3. Close the door until it is at an angle
of approximately 45°.
4. Hold the door with one hand on
each side and pull it away from the
appliance at an upwards angle.
Put the door with the outer side
down on a soft and level surface
to prevent scratches.
5. At this time you can remove the in-
ner glass panels and clean them.
To install the door do the above steps in
the opposite sequence.
18 www.aeg.com