AEG DC4003000M - Manual (Page 19)

2
B
1
Removing and cleaning the door
glasses
The door has 2, 3 or 4 panels of
glass (the number depends on
the model).
CAUTION!
Rough handling of the glass, es-
pecially around the edges of the
front panel, can cause the glass
to break.
1. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
2. Pull the door trim to the front to re-
move it.
3. Hold the door glass panels on their
top edges one by one and pull
them upwards from the guide.
4. Clean the door glass panels.
To install the panels do the above
steps in the opposite sequence. In-
sert the smaller panel first, and then
the larger one.
9.4 Oven lamp
WARNING!
There is a danger of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Put a cloth on the bottom of the
oven for protection of the oven
light and glass cover.
Replacing the oven lamp
1. You can find the lamp glass cover at
the back of the cavity.
Turn the lamp glass cover counter-
clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with applica-
ble 300°C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
10. WHAT TO DO IF…
WARNING!
Refer to the Safety chapters.
Problem Possible cause Remedy
The oven does not heat
up. The appliance is deacti-
vated. Activate the appliance.
ENGLISH
19