AEG DC4003000M - Manual (Page 7)

After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
To change the time, press
again and again until the indica-
tor for the Time of Day function
flashes. You must not set the Du-
ration
or End function at
the same time.
To use the appliance, push the control
knob. The control knob comes out.
4.3 Preheating
Preheat the empty appliance to burn off
the remaining grease.
Preheat the two ovens. Heat up one
oven at a time.
Set the functions listed below, if applica-
ble.
1.
Set the function and the maxi-
mum temperature.
2. Let the appliance operate for one
hour.
3.
Set the function and the maxi-
mum temperature.
4. Let the appliance operate for ten mi-
nutes.
5. Set the function and the maxi-
mum temperature.
6. Let the appliance operate for ten mi-
nutes.
Accessories can become hotter than
usually. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow is sufficient.
5. DAILY USE
WARNING!
Refer to the Safety chapters.
5.1 Activating and
deactivating the top oven
1. Turn the knob for the top oven func-
tions to an oven function.
2. Turn the knob for the top oven tem-
perature to a temperature.
The power indicator comes on while
the appliance operates.
The temperature indicator comes on
while the temperature in the appli-
ance increases.
3. To deactivate the appliance, turn the
knob for the top oven functions and
the knob for the top oven tempera-
ture to the Off position.
5.2 Activating and
deactivating the main oven
1. Turn the knob for the main oven
functions to an oven function.
2. Turn the knob for the main oven
temperature to a temperature.
The power indicator comes on while
the appliance operates.
The temperature indicator comes on
while the temperature in the appli-
ance increases.
3. To deactivate the appliance, turn the
knob for the main oven functions
and the knob for the main oven tem-
perature to the Off position.
ENGLISH
7