Olympus E-300 - Manual (Page 147)

9
Printing
147
Use the USB cable provided to connect the camera to a PictBridge-compatible
printer. The procedure described below is for when the PC mode is set to AUTO in
the menu. If you set the PC mode to PRINT beforehand, you can skip this
procedure.
1
Turn the printer on and plug the
printer end of the USB cable into the
printer’s USB port.
● For details on how to turn the printer on and
the position of the USB port, refer to the
printer’s instruction manual.
2
Plug the USB cable into the camera’s
USB connector and turn the camera
on.
● The selection screen for the USB connection
is displayed.
3
Select PRINT.
● ONE MOMENT is displayed and the camera
and printer are connected. The PRINT MODE
SELECT screen is displayed on the monitor.
4
Go to “Flowchart for printing”
( ~ P. 148).
Connecting the camera to a printer
Direct printing (PictBridge)
USB connector
P C
PRINT
EXIT
USB
SELECT GO
If the screen is not displayed after a few minutes, turn off the camera and start
again from Step 2.
Note
09E-300EN-P137 04.10.22 11:34 AM Page 147