Olympus E-300 - Manual (Page 74)

4
V
arious shooting functions
74
Remote control lamp
Remote control receiver
Using the remote control
1
Mount the camera on a tripod or place
it on a stable, flat surface.
2
Point the remote control at the remote
control receiver on the camera and
press the shutter button on the remote
control.
● When is selected: The focus and exposure
are locked, the remote control lamp blinks
and the picture is taken.
When is selected: The focus and exposure
are locked, the remote control lamp blinks
and the picture is taken after approximately 2
seconds.
Approx. 2m (6.6 ft.) (outdoor)
Approx. 3m (9.8 ft.) (indoor)
Approx. 3m (9.8 ft.) (indoor)
Approx. 2m (6.6 ft.) (outdoor)
15 °
15
°
Approx. 5m (16.4 ft.) (indoor)
Approx. 3m (9.8 ft.) (outdoor)
Camera
Remote control receiver
Transmitted signal effective area
Point the remote control at the remote control receiver of the camera within the
effective area as shown below.
Powerful lighting such as direct sunlight, fluorescent light or devices emitting
electrical or radio waves could narrow the effective area.
Drive mode
Remote
control
04E-300EN-P53 04.10.22 11:22 AM Page 74