Boss Audio Systems BR-600 - Manual (Page 116)

116
Mastering Tool Kit Parameter Functions
Re
v0.10
This is a filter that cuts unwanted low range noise, such as
pops.
On/Off OFF, ON
This setting turns the Bass Cut Filter on/off.
Freq 20 Hz – 2.0 kHz
This sets the frequency containing popping or other
undesirable lower-range noises that you want to cut.
This adds more liveliness to the sound, putting sounds at
the forefront.
On/Off OFF, ON
This parameter turns the enhancer effect on/off.
Sens 0 – 100
This sets the amount of Enhancer that is applied.
Freq 1.0 – 10.0 kHz
Sets the frequency at which the enhancer effect will begin to
be applied.
Mix Lvl -24 – +12 dB
Sets the volume of the effect sound.
This divides the original sound into three frequency ranges:
low, mid, and high.
Gain -24 – +12 dB
Sets the overall volume level before the signal passes
through the expander/compressor.
Dly Time 0–10 ms
This sets the amount of time by which the source input
sound is delayed.
SplitL 20 – 800 Hz
This sets the frequency (in the lower range) at which the
source sound is split into three separate ranges.
SplitH 1.6 – 16.0 kHz
This sets the frequency (in the upper range) at which the
source sound is split into three separate ranges.
This expands the dynamic range at a fixed ratio.
On/Off OFF, ON
This setting turns the expander on/off.
Lo Thres -80 – 0 dB
This sets the volume level at which the lower-range
expander goes into effect.
Lo Ratio 1:1.00 – 1:16.0, 1:INF
This sets the ratio of increase in output of the lower range
when the input level falls below the Lo threshold level.
Lo Attack 0 – 100 ms
This sets the time it takes for the lower-range expander to
go into effect once the input level falls below the Lo
threshold level.
Lo Release 50 – 5000 ms
This sets the time it takes for the lower-range expander effect
to stop once the input level exceeds the Lo threshold level.
Mid Thres -80 – 0 dB
This sets the volume level at which the midrange expander
goes into effect.
Mid Ratio 1:1.00 – 1:16.0, 1:INF
This sets the ratio of increase in output of the midrange
when the input level falls below the Middle threshold level.
Mid Attack 0 – 100 ms
This sets the time it takes for the midrange expander to go
into effect once the input level falls below the Middle
threshold level.
Mid Release 50 – 5000 ms
This sets the time it takes for the midrange expander effect to
stop once the input level exceeds the Middle threshold level.
Hi Thres -80 – 0 dB
This sets the volume level at which the upper-range
expander goes into effect.
Hi Ratio 1:1.00 – 1:16.0, 1:INF
This sets the ratio of increase in output of the upper range
when the input level falls below the Hi threshold level.
Hi Attack 0 – 100 ms
This sets the time it takes for the upper-range expander to
go into effect once the input level falls below the Hi
threshold level.
Hi Release 50 – 5000 ms
This sets the time it takes for the upper-range expander effect
to stop once the input level exceeds the Hi threshold level.
Bass Cut Filter
Enhancer
Input
Expander