Re v0.10, No song, Not available in mastering mode – Boss Audio Systems BR-600 User Manual
Page 217: Power down, Protected, Set the repeat, Stop p.trainer, Stop recorder, Too many songs, Unformatted
217
Error Messages
Re
v0.10
Section 7
No Song!
Cause :
There are no songs on the memory
card.
Solution :
Cause :
Incorrect data is in the song folder, or
the necessary data is not present.
Solution :
Restore the data backed up on the
computer to the BR-600. In this case,
restore each “ROLAND” folder to the BR-
600 (p. 165, p. 179).
Not Available in Mastering Mode!
Cause :
You cannot carry out this operation with
“MASTERING” selected as the recording
mode.
Solution :
First press the [REC MODE] button to
switch the recording mode to “INPUT”
or “BOUNCE,” then proceed with the
operation.
Power Down!
Cause :
Internal power source voltage is below
than guaranteed workable range.
Solution :
In case of using PSA adaptor :
Cable might be broken or adaptor itself
might be malfunctioning. Please contact
Roland Service or Roland authorized
dealers.
In case of using batteries :
Please replace with new batteries (p. 24).
Protected!
Cause :
You are attempting to write data to a
song that has protection switched on.
Solution :
To write data to the song, switch Protect
to OFF (p. 88).
Set the Repeat!
Cause :
Repeat A (Starting Point) and B
(Ending Point) is not set.
Solution :
Set the Repeat A and B (p. 58).
Stop P.Trainer!
Cause :
The operation you attempted cannot be
done while the Phrase Trainer (p. 195)
is operating.
Solution :
Press [PHRASE TRAINER] to turn off
the Phrase Trainer.
Stop Recorder!
Cause :
The operation you attempted cannot be
done while the recorder is running
(playing or recording).
Solution :
Press [STOP] to stop playback or
recording.
Too Many Songs!
Cause :
You are attempting to create more that
100 songs.
Solution :
Unformatted!
Cause :
The Memory card is not formatted by
DOS.
Solution 1 : Turn off the BR-600, properly insert the
memory card, then turn the BR-600BR-
600 back on.
Solution 2 : Initialize the card (p. 199).
Unsupported Card!
Cause :
The memory card (CompactFlash) or
MicroDrive inserted is not compatible
with the BR-600.
Solution :
Use a memory card compatible with the
BR-600 (32 MB to 1 GB CompactFlash
with a power-source voltage of 3.3 V).
Unsupported Format!
Cause 1 :
The BR-600 cannot recognize or use the
format of the inserted memory card.
Solution 1 : Insert a memory card initialized for use
Cause 2 :
You have attempted to load an
incompatible WAV or AIFF file or SMF
to the BR-600.
Solution 2 : Check the format of the WAV or AIFF file
or SMF.