Software upgrade and licenses, System information and reset tv, System information automatic power down reset tv – Toshiba SV685 User Manual
Page 47
47
CONTROLS AND FEATURES
Software Upgrade and Licenses
When Auto Upgrade is set to On (default setting), the
television will automatically upgrade while in standby if new
software is available.
a
From the SETUP menu, press
B
or
b
to select
Software Upgrade
and press
Q
.
b
Press
b
to select Auto Upgrade.
c
Use
C
or
c
to select On or Off.
If preferred, software upgrades can be searched for manually
using Search for New Software.
a
In the Software Upgrade menu, press
B
or
b
to
select Search for New Software.
b
Press
Q
. The television will automatically start
searching for a software upgrade, the progress bar
will move along the line.
If an upgrade is found, the television will
automatically start downloading. If not, a screen will
appear stating that an upgrade is unavailable.
The Licenses for the software used in this television are
available for viewing.
a
In the SETUP menu, press
B
or
b
to select Software
Licences
and press
Q
.
A screen will appear displaying all the licensing
information required for the televisions software.
System Information and Reset
TV
This feature can be used to check the version of software
currently installed. When in DTV mode, it includes additional
diagnostic information such as signal strength, signal quality,
centre frequency, modulation, etc.
a
From the SETUP menu, press
B
or
b
to select System
Information
.
b
Press
Q
to display the System Information.
c
For information about the signal quality of a
particular multiplex, press
B
or
b
to select that
multiplex.
d
Press
Q
for a screen showing detailed technical
information about the selected multiplex.
The TV will automatically turn itself off (standby) after
approximately 4 hours, if you don't touch the control buttons
on the remote control or on the TV control panel.
a
In the SETUP menu, press
b
until Automatic Power
Down
is highlighted.
b
Use
C
or
c
to select On.
Selecting Reset TV will reset all TV settings, including saved
channels, to their original factory values.
a
In the SETUP menu, press
b
until Reset TV is
highlighted.
b
Press
Q
to select. A screen will appear warning that
all settings will be lost. Press
Q
to continue.
When the set powers back on, the Quick Setup
screen will appear. Press
Q
to advance the setup
and perform an auto tune. (See ‘Quick Setup’ section
on page 14.)
Auto Upgrade
Searching for New Software
Software Licenses
SEARCHING FOR NEW SOFTWARE
Searching for a new software upgrade for this TV.
Searching
System Information
Automatic Power Down
Reset TV
TOSHIBA
System Information
2009
2.1.26.0 Feb 19 2009 - 15:56:50 FW:13
WEAK
Ch22
Poor
Ch25
Good
Ch35
Good
Ch46
Good
AVERAGE
STRONG